The Accord chassis has an inherent issue with the stock camber arms wearing to the point where they can no long be adjusted back into spec, leading to tramlining and pulling to either side. This was corrected on later years and a TSB (technical service bulletin) was issued by Honda informing dealership staff how to deal with the issue.
Whether you're wanting to correct your alignment due to the issue above, you're lowering your car, or attempting a fast-road set-up, CT Engineering camber arms have you covered.
These arms are very easy to replace and simply swap out for the stock rear upper arms.
- Camber adjuster-rear (-1.5 to +3 deg.)
- Uses a rubber bushing
- Normally sold invidually by CT-E, we provide them in pairs.
- Application: 02-08 Honda Accord
- Installation time: 1/2 hour +/-