Engine & Gearbox Doing a engine swap need help.....d14z4 to a b16a2

Discussion in 'Honda B-Series' started by M12_JDM, Tuesday 29th Dec, 2009.

  1. M12_JDM Club Member ★ ☆ ☆ ☆ ☆

    41
    Hi, iv recently bought a b16a2 and would like to drop it into my ek4 shape hatchback Civic, which currently has a D14Z4 wngine in it.... Couple of questions....


    1.) Would the d14 gear box run good with the b16 engine?


    2.) Engine mounts.... are they the same?


    3.) If some one can please run me through a quick gudie on how to do it including rear drums to discs conversion.


    Thank You
     
  2. DanF Club Veteran ★ ★ ★ ★ ★

    http://www.civiclife.net/forum/showthread.php?t=60447


    drums to discs. PM me if your confused at all
     
  3. Site Club Veteran ★ ★ ★ ★ ★

    no the gearbox...get yourself a cheapish Y21 gearbox....


    I think a few of the mounts are the same, but you will need some b-series ones....so just get a full set to make sure...


    and dan just sent the link for rear drums to discs....
     
  4. Matty Valued Contributor ★ ★ ★ ☆ ☆

    1.) Would the d14 gear box run good with the b16 engine?


    No will need B series gearbox


    2.) Engine mounts.... are they the same?


    No you will need all the mounts from a EK4


    3.) If some one can please run me through a quick gudie on how to do it including rear drums to discs conversion.


    As above
     
  5. gumbar Top Contributor ★ ★ ★ ★ ☆

    Its not a hard swap to be honest because all you have to do is find a fucked ek4, nik the stuff off it and sorted! even if you want to go 282's instead of 262's you will have the hubs you need anyway so you will just need the caliper's
     
  6. al9955 Club Veteran ★ ★ ★ ★ ★

    4,590
    31
    this is incorrect, the 2 upper D14 engine mounts will work with a B16, you only need the 2 lower and the rear t shaped mounts from an EK4/EK9


    al9955