Engine & Gearbox b16 into DX , fuel tank/pump issue

Discussion in 'Honda B-Series' started by Jake@redbitz, Tuesday 24th Nov, 2009.

  1. Jake@redbitz Top Contributor ★ ★ ★ ★ ☆

    Heya , doing a b16 engine conversion soonish into a (possible dx)


    If i go ahead , what exactly does it need in that area...


    vti/esi/lsi fuel tank and pump and lines??


    Anybody? Thanks..:Tongue:
     
  2. v-techcivic Club Member ★ ☆ ☆ ☆ ☆

    158
    obvo u will need a loom out of vti/esi.... vti or esi tank as far as i no same with fuel lines mate!!
     
  3. Jake@redbitz Top Contributor ★ ★ ★ ★ ☆

    I know everything loom engine shafts wise... Just not tank.
     
  4. Civic Coupe EJ2 Top Contributor ★ ★ ★ ★ ☆

    as far as I know.....when doing mine....into a LSI...all the fuel lines, fuel pump and fuel filter are the same......haven't had any issues with them....
     
  5. ek-greeny Club Veteran ★ ★ ★ ★ ★

    Yeah but dx's are carbed
     
  6. Civic Coupe EJ2 Top Contributor ★ ★ ★ ★ ☆

    oh dame just remembered....hopefully someone whos done a conversion can clear this up....
     
  7. ryjay Club Member ★ ☆ ☆ ☆ ☆

    86
    pretty sure you'll basically need a donor car, me and a friend have recently completed a d15(carb CR-X) to B16 conversion, the whole loom.,fuel lines and tank,brake and hub setup all had to be swapped over from the donor car,so i'm assuming with a Civic DX you'll be in the same boat,hope this helps.
     
  8. jonesy_eg Senior Member ★ ★ ☆ ☆ ☆

    i done the swap into a marlin i had to change the


    engine mounts


    engine loom


    dash loom


    fuel tank


    fuel lines


    fuel tank sender unit on top of tank


    and modified the clocks to fit


    had to re pin the rear clip to match up with the Del Sol loom in the front
     
  9. stone119 Club Member ★ ☆ ☆ ☆ ☆

    80
    ye i done this swap to ,then upgraded to a b18c . Love the Dx as a base car.
     
  10. PittStop Top Contributor ★ ★ ★ ★ ☆

    if you want an easy swap, the dx is not the right shell, if you use an lsi you only have to change the looms, its a right wanker changing the fuel lines and tank.
     
  11. ryjay Club Member ★ ☆ ☆ ☆ ☆

    86
    agreed! not a job i'd fancy doing again in a hurry!
     
  12. jonesy_eg Senior Member ★ ★ ☆ ☆ ☆

    i love how they fit under the subframe massive ball ache tempted to get mine all braided


    if you get any snags pm me il try and help