Lift and Safety Stands
- Difficulty Level:
Basic
Place the lift blocks as shown.
Raise the hoist a few inches (centimetres), and rock the vehicle to be sure it is firmly supported.
Raise the hoist to full height, and inspect the lift points for solid support.
NOTE: Use the same support points to support the vehicle on safety stands.
![]()
Floor Jack
Set the parking brake, and block the wheels that are not being lifted.
When lifting the rear of the vehicle, put the shift lever in P position.
Raise the vehicle high enough to insert the safety stands.
Adjust and place the safety stands so the vehicle will be approximately level, then lower the vehicle onto them.
![]()